"Custom" Cab Sail Molding - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**damnyankee36** · 12-25-2018, 03:53 PM

Can anyone tell me what orientation the sail panel mounting clip is supposed to be?

The holes aren't centered so it looks like it should only install one way to allow the molding edge to catch. But either way I install it there isn't a gap between the clip and cab to allow the molding edge to slide under the clip.

The first pic shows the way I think it should go. It seems like a spacer or washer would work but I don't remember seeing that when I removed the clips years ago.

12-25-2018, 03:53 PM	#1
damnyankee36 Senior Member Join Date: Sep 2002 Location: Alamogordo, NM Posts: 724	"Custom" Cab Sail Molding Can anyone tell me what orientation the sail panel mounting clip is supposed to be? The holes aren't centered so it looks like it should only install one way to allow the molding edge to catch. But either way I install it there isn't a gap between the clip and cab to allow the molding edge to slide under the clip. The first pic shows the way I think it should go. It seems like a spacer or washer would work but I don't remember seeing that when I removed the clips years ago. Attached Images

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.