Moog ball joint on cpp upper tubular - The 1947 - Present Chevrolet & GMC Truck Message Board Network

f.flujan · 12-26-2018, 12:08 PM

I have brand new moog upper ball joints that were going into rebuilding my old set on my 1968 c10. Ended up buying cpp's upper tubulars. Uppers are new from cpp but would like to put my new MOOG's in and use cpp's as back up. This is a frame off and since I've heard nothing but good about MOOG i want to start off with them. QUESTION is do i put the MMOG ball joint in as recommended by MOOG (from the top) or put them in like CPP does theirs (from the bottom)
thanks for any help

12-26-2018, 12:08 PM	#1
f.flujan Registered User Join Date: Dec 2016 Location: Menifee,ca Posts: 65	Moog ball joint on cpp upper tubular I have brand new moog upper ball joints that were going into rebuilding my old set on my 1968 c10. Ended up buying cpp's upper tubulars. Uppers are new from cpp but would like to put my new MOOG's in and use cpp's as back up. This is a frame off and since I've heard nothing but good about MOOG i want to start off with them. QUESTION is do i put the MMOG ball joint in as recommended by MOOG (from the top) or put them in like CPP does theirs (from the bottom) thanks for any help

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.