|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-26-2018, 01:57 PM
|
#1 |
|
Senior Member
  
Join Date: Feb 2009
Location: Northern Nevada
Posts: 7,385
|
Rebuild front suspension with or without upper control arm shims?
For what it's worth this is a frame-off project. As shown in the image, I found the upper control arms using two 1/8" shims at the rear and two 1/8"shims at the front. The fronts had two 1/16" shims as well, which I suspect were added post factory, but who knows.
Do you recommend I rebuild this with the same shim configuration or? It has to go in for alignment anyway, but....... Thank you
__________________
Tony 71 Custom Deluxe, SWB, 2WD, 402, A/C. I developed an assembly guide (kit) for restoring this truck from the ground up, complete with details including full hardware descriptions. Much of the info. applies to all 67-72 GM. My build thread, with some info. about the assembly kit https://67-72chevytrucks.com/vboard/...d.php?t=730025 |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode