Depinned engine harness --- now ... ?? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

FAKKY · 03-10-2019, 01:05 PM

So unloomed and depinned this bad boy about 6+ months back.
Now looking to finish it off and get it into they truck.

Whats the best approach here ? Stuff like ....

Routing and lengthening/shortening wires ..... which ones typically ..... injectors seem to be a standout as they are in completely different positions. eg first part of harness from the PCM .... .annd then about smack bang in middle of the middle run.

Grounds - how many should there be ? Where do they connect (Harness was removed by a friend whilst I was dissaembling the trans).

Other suggestions ?

This a 2007 lq4 6.0.

03-10-2019, 01:05 PM	#1
FAKKY Registered User Join Date: Sep 2016 Location: Redington Beach Posts: 1,317	Depinned engine harness --- now ... ?? So unloomed and depinned this bad boy about 6+ months back. Now looking to finish it off and get it into they truck. Whats the best approach here ? Stuff like .... Routing and lengthening/shortening wires ..... which ones typically ..... injectors seem to be a standout as they are in completely different positions. eg first part of harness from the PCM .... .annd then about smack bang in middle of the middle run. Grounds - how many should there be ? Where do they connect (Harness was removed by a friend whilst I was dissaembling the trans). Other suggestions ? This a 2007 lq4 6.0. __________________ FAKKY 57 PANEL BUILD Last edited by FAKKY; 03-10-2019 at 01:12 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.