The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > Welcome and Discussion > Welcome Area

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-11-2019, 09:37 PM   #1
Nubs32
Registered User
 
Join Date: Feb 2016
Location: Sturgis sd
Posts: 8
Hello. 70cst

New to forum , although not an expert I’ve always been a fan of 67-72 chevys. I recently acquired a 70 cst lwb. It’s a one family owned truck with 53k miles. Paint is faded and peeling where copper was sprayed over white on cab. Has one small rust hole in cab corner and one outer rocker has about a 3 inch rust hole , that’s it. Interior is very nice. Sat for a few years but fired right up with fresh fuel and runs good. Truck is all original with the addition of under dash ac. I removed Box to replace wood floor. My vision was to (gulp) cut the frame and bed sides , lower , disk brakes, big inch small block. you know the drill. But now I’m wondering if this one should just be cleaned up and driven or restored original. Has spid and build sheet. I didn’t take a pic of spid yet. 350/350 Posi. Any thoughts ?....
Attached Images
     
Nubs32 is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:34 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com