started building my 441 heads. tips 4 ya,ll - The 1947 - Present Chevrolet & GMC Truck Message Board Network

BCOWANWHEELS · 05-29-2019, 10:06 PM

today I started building my 441 heads and thought I,d share a couple tips I,ve learned over the years.

1. when going to screw in rocker studs and guide plates.. YOU MUST DRILL OUT THE FACTORY OVAL SHAPED HOLES FOR PUSHRODS TO 7/16. USE A NEW DRILL BIT WITH A DRILL PRESS...............AND USE CUTTING OIL GENEROUSLY........

2. WHEN REMOVING PRESS IN ROCKER ARM STUDS........... HEAT STUD BOSS BEFORE YOU START THE PULLING PROCESS.

MORE TO COME
BOB

05-29-2019, 10:06 PM	#1
BCOWANWHEELS Registered User Join Date: Nov 2006 Location: KINGSPORT,TN. Posts: 3,035	started building my 441 heads. tips 4 ya,ll today I started building my 441 heads and thought I,d share a couple tips I,ve learned over the years. 1. when going to screw in rocker studs and guide plates.. YOU MUST DRILL OUT THE FACTORY OVAL SHAPED HOLES FOR PUSHRODS TO 7/16. USE A NEW DRILL BIT WITH A DRILL PRESS...............AND USE CUTTING OIL GENEROUSLY........ 2. WHEN REMOVING PRESS IN ROCKER ARM STUDS........... HEAT STUD BOSS BEFORE YOU START THE PULLING PROCESS. MORE TO COME BOB __________________ I BELIEVE IN JOHN 3:16

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.