MD rocker boxes & more

[richard2717]

***DISCLAIMER*** these are home made pcs that I acquired that look close but I have no idea if they fit

I already bought the parts I need for my Blazer and happened on these. The rocker boxes are lighter gauge metal ( i am guessing no more than 18 ga) than the aftermarket ones I purchased. I do not know if they will be structural enough or not. I put the passenger side one up under my 72 and it seems to fit in place pretty good. these weight 12# each compared to the tri plus ones I have at 19# each. One other thing I noticed is the lip that bends toward the outer rocker is not a brake bend. Looks like it was hand bent. I am going to see if it will fit in my 10' brake tomorrow and see if I can clean that bend up some but I am not sure if it will fit in there or not.

The other 4 under body parts for the 1/4 seem to be close as well when I compare them to the ones I have sitting here. I do not have anything torn apart enough to see if they actually fit. No holes have been drilled in any of it.

For this reason I am going to sell them pretty reasonable with the understanding they may or may not actually work out of the box. I did not make them so I can't say with any certainty they are 100% correct. You might be getting a deal or you might be getting extra fab work. The choice is up to you.

All six pcs $175 plus shipping


.