Question about harmonic balancers... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

n737nc · 07-06-2004, 10:04 AM

Still green, getting the stupid questions out of the way.

If you have one size balancer, do you have to stay with that same size?

Reason that I am asking is I have a larger balancer on my motor(7.5inch). But, the balancer is too narow that the timing tab covers it up(picture). So, when I time the motor, I have to time it to 16, then guess from there.

Can I change my balancer to a smaller one? If so, what size do I need?

Thanks,
Nick

07-06-2004, 10:04 AM	#1
n737nc Registered User Join Date: Jun 2004 Location: Dallas, Tx Posts: 207	Question about harmonic balancers... Still green, getting the stupid questions out of the way. If you have one size balancer, do you have to stay with that same size? Reason that I am asking is I have a larger balancer on my motor(7.5inch). But, the balancer is too narow that the timing tab covers it up(picture). So, when I time the motor, I have to time it to 16, then guess from there. Can I change my balancer to a smaller one? If so, what size do I need? Thanks, Nick Attached Images

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.