|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-14-2021, 07:06 AM
|
#1 |
|
Registered User
Join Date: Apr 2015
Location: East Tn (In the heart of the Smoky Mtns)
Posts: 1,897
|
Balancing a two-piece driveshaft
I was just reading another thread about removing a two-piece driveshaft, and another member mentions marking the shaft before disassembly, because they’re balanced from the factory.
I’ve had mine apart 3-4 times to replace the carrier bearing, and didn’t know about this detail. Is there a way to line up the two halves to get the DS back in balance? Just curious |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode