|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-03-2021, 10:04 AM
|
#1 |
|
Almost Satisfied
 
Join Date: Mar 2002
Location: Springfield, MO
Posts: 2,932
|
Holley Sniper Dual Plenum Intake
I'm looking at this intake and it isn't real clear on what else you need to make it work. Has anyone installed one of these yet?
I am starting out with an DBW Lq4 and you clearly can't use the stock throttle body and I am not sure where the MAF sensor comes in. I can't find dbw throttle bodies that seem to fit this and so I became discouraged with this option and went back to looking at the Holley Long Tunnel Intake. I ran into the same roadblocks with it and the throttle body. On another note...I am running my stock injectors still and would like to upgrade them. Suggestions on what to go with. I believe my 05 motor uses the mini plugs on the injectors so it looks like an adapter wire will be be needed. Thanks,
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far." |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode