NV4500 Swap Questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**66gmcguy** · 12-18-2021, 10:43 PM

Hello folks. I apologize if this has been discussed before, but I just picked up an NV4500 to swap into my K20. The transmission is from an LS based truck and includes the bellhousing. What's involved in mating this to my engine? I have a Vortec 350, SM465, and a factory hydraulic clutch setup with an aftermarket external slave cylinder. Can I use the LS bellhousing? What other parts do I need (clutch release bearing, slave cylinder, clutch, etc)?

12-18-2021, 10:43 PM	#1
66gmcguy Senior Member Join Date: Oct 2014 Location: Bay Area, CA Posts: 346	NV4500 Swap Questions Hello folks. I apologize if this has been discussed before, but I just picked up an NV4500 to swap into my K20. The transmission is from an LS based truck and includes the bellhousing. What's involved in mating this to my engine? I have a Vortec 350, SM465, and a factory hydraulic clutch setup with an aftermarket external slave cylinder. Can I use the LS bellhousing? What other parts do I need (clutch release bearing, slave cylinder, clutch, etc)?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.