Driveshaft hitting cross member

[Bret B]

Guys, need some recommendations. Issue is, when lifting the truck at the frame, as the suspension extends, the driveshaft makes contact with the trailing arm crossmember. This was quite a surprise and not something foreseen. Once contact was imminent, we didn't lift any further, so I don't know if we were at or just about full extension.

Truck is a 1965 C10 short box, step side. Engine is an LQ4,4L80E. 12bolt rear end. Using a 1 piece driveshaft, believe it is a 4in diameter maybe 3.5 inch. All the suspension and crossmembers are CPP tubular. Drop is 5 inches I believe. Engine mounts are CPP "plate" perches with dirty dingo sliders. Engine is in full AFT position on the sliders. Trans mount is CPP with a Summit rubber mount. Truck can be driven, but no exhaust causes frowny faces by neighbors. Mechanic in town making the exhaust found this driveshaft hitting cross member problem. Said the trans and trailing arm members were install upside down and driveline angles were completely wrong. That started me down the rabbit hole. For clarification, no, the mount and crossmember aren't upside down. Both are installed per the instructions from CPP and I've doubled down with checking the web, and articles in magazines. Driveline angle, could play in, or does it?

Pics attached in this order: 1. Rear end angle 2. up close of pinion angle (6 degree) 3. Trans angle, don't know why it is upside down when uploaded. 4 up close of trans angle (-6.5 degree), same upside down graphic. 5. Cross member

Rear end angle is 6 degrees (pinion pointing up). Trans is -6.5 (pointing down). I didn't think the driveshaft angle was important, but guessing it is after reading the interwebs. I'll get that when it isn't so damn cold outside. However, the distance from driveshaft to crossmember where contact is made, at ride height, is about 1 inch. Now, the mechanic said I needed to raise the transmission mount up to make a better angle. So, I raised the trans off the mount 3/4 of an inch. The transmission angle then is -6 degrees. This I'm assuming is goodness. Yet that did nothing for resolving the driveshaft contacting crossmember, or very little improvement anyway.

I contacted CPP and tech support said he hasn't heard of this issue before. Their kits are designed for 1pc or 2pc driveshaft, but it is the first time he's heard of it. He didn't say it isn't possible, but clarified people who may experience this, haven't reported it and probably solved it without calling. He said options were limited. 1. I could cut mounts of rear end and re-position to make 4 degrees. Remove the engine perches and install OEM perches to lower the engine and raise trans rubber mount to obtain -4 degrees. 2. I could make limiting straps so the suspension doesn't extend. I see how this could work but ask myself why would I have to, the problem is still there. 3. Install a 2pc driveshaft, but I'd need to get the 4 degree angles.

This leads to the questions. What am I doing wrong, no one else seems to have problems with? What if I went to a 2 piece driveshaft? How would the pinion and transmission angles play in with a 2pc unit? Or, do I really have to worry about the angles if using a 2pc? Now, I don't want to throw away $600 for the driveshaft I had made. Money is money and it isn't free flowing. The angles currently are what they are from the geometry of the kit I bought from them. I didn't add or subtract a component to alter the results.

Input and ideas would be appreciated.