The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1969 - 1972 Blazers and Jimmys Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-29-2023, 08:48 AM   #1
scott123
Registered User
 
Join Date: Dec 2007
Location: Middleburg, North Carolina
Posts: 480
Orange is the new $$$$

I bought this Blazer several years ago. It was primed black, with big hooptie wheels, a 68 front clip and a cowl induction hood. It would crank by just about looking at it and I never had a minute of trouble. I drove it everywhere and anywhere if the sun was out.

I ditched the 68 front clip with the cowl induction hood, ditched the hoopties and painted it orange.

Never paint anything orange. LOL

When completed I pulled it out of the shop, admired the new look and made the first drive as a stock looking Orange 72 K5.

I made it to the end of our road and it started running hot. The thermostat switch failed and the fans did not come on. I ordered another switch and took off on my next voyage. Again, ran hot. I replaced the relay and the cooling issues was resolved. I drove it around the block a few times and all was well. The next morning the anti-freeze on the floor said otherwise. The water pump was leaking from the weep hole so I pulled it all down and replaced the water pump and the belts while I was there.

Pulled it out of the shop and as I rolled down our path it stumbled and died. I pulled it back in the yard and I was getting no gas. Filled the bowl and it fired right up but died.

Sending unit shows a half tank but sounds empty tapping on it so today will be 'is it the sending unit or the fuel pump'.

I have looked all over the front end to see if I pinched a wire or damaged a wire changing out the front clip. I even scratched the shiny new orange paint to get a good ground.

I am thinking I should have left well enough alone and just lived with the ugly ass wheels and the cowl induction hood.

(forgot to add while swapping out the hooptie wheels I saw grease and found the rear axle seal was leaking. I pulled all that down and replaced the axle seal. Moving the axle back in the spider gear fell out and I wrestled them for an hour getting them back in place)

I am beginning to think it is the Orange paint that caused all this 'pain and suffering'. LOL

Scott
Attached Images
 
scott123 is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:24 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com