Installing carpet in a 4x4 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Yukon Jack** · 03-21-2005, 11:41 AM

Am I correct in assuming carpet in a 4x4 cab is not glued down? I assume it is not glued down so you can pull it up to get to the tranny hump.

Got some of the insulation installed this weekend and test fit my late model seats.

Also, should the insulation go to the edge of the door opening like in this pic or should I cut it back so when I install the sill plate it is only on top of the carpet but not on top of insulation? Was worried the thickness of carpet and insulation might make a problem.

03-21-2005, 11:41 AM	#1
Yukon Jack Post Whore Join Date: Feb 2000 Location: Rose Hill, KS, USA Posts: 12,686	Installing carpet in a 4x4 Am I correct in assuming carpet in a 4x4 cab is not glued down? I assume it is not glued down so you can pull it up to get to the tranny hump. Got some of the insulation installed this weekend and test fit my late model seats. Also, should the insulation go to the edge of the door opening like in this pic or should I cut it back so when I install the sill plate it is only on top of the carpet but not on top of insulation? Was worried the thickness of carpet and insulation might make a problem. __________________ 1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 Last edited by Yukon Jack; 06-24-2010 at 11:17 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.