|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-26-2005, 08:16 PM
|
#10 |
|
Sanity is a state of mind
Join Date: Apr 2005
Location: New Humpshire
Posts: 93
|
Yes, a fish plate on one side will work, but do not weld a continous bead all around. stitch weld it(1"weld leave a few inches, another 1" weld leave a few). I like to start at a corner and weld 1" up and 1" over. I nail all four corners and stitch in between.
Good luck.......
__________________
67 K-10 8ft step 250/465/timken 4 shaft/373 to 1 70 C-10 Panel Vortec V/5spd BW od /307 to 1 70 C-30 9ft stepside dump 350/465/ posi and a few too many other trucks, cars, jeeps, cruisiers, and M/Cs ...o~`o |
|
|
| Bookmarks |
|
|
Threaded Mode