Angle of splined yoke on two piece driveshaft - The 1947 - Present Chevrolet & GMC Truck Message Board Network

JimKshortstep4x4 · 06-09-2005, 07:39 AM

Does anyone know what angle the splined yoke goes onto the front section of the driveshaft on a C-10 two piece drive shaft?

It is a 71 C-10 with the factory two piece drive shaft and the yoke fits onto the front shaft just to the rear of the midship bearing support.

The service manual is not clear and the illustration is of the older style drive shafts so it is not much help.

Assistance will be appreciated!

Jim

06-09-2005, 07:39 AM	#1
JimKshortstep4x4 Senior Member Join Date: Jul 2001 Location: Muskegon,MI,USA Posts: 6,026	Angle of splined yoke on two piece driveshaft Does anyone know what angle the splined yoke goes onto the front section of the driveshaft on a C-10 two piece drive shaft? It is a 71 C-10 with the factory two piece drive shaft and the yoke fits onto the front shaft just to the rear of the midship bearing support. The service manual is not clear and the illustration is of the older style drive shafts so it is not much help. Assistance will be appreciated! Jim



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.