Goodmark Sheetmetal, good or bad?

[67ChevyRedneck]

I have extra money finally (96 hours of comp time, WOHOO) and my truck needs some parts. I am close enough to where I can drive to the goodmark store in lawrenceville, GA (my gf goes to uga which isnt too far from there). I've read a few scattered opinions on this stuff. Here goes....

How do the 67 front fenders fit? How do the doors fit? I am contemplating buying two doors and two fenders. I have measurements of various areas of my doors and fenders I will take with me, if they are not close enough to stock, I will not purchase them. For those who say they fit poorly, how so? Did the bolt holes not align? Did the body lines not align? Were they too wide or short? I will probably be heading down there in a month or so. I'd like to start out with brand new parts for once, tired of rust. Opinions from people who have actually used these parts will be greatly appreciated.