|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
02-19-2006, 10:40 PM
|
#1 |
|
Professional Grade
Join Date: May 2003
Location: Fort McMurray, Alberta
Posts: 7,915
|
Source for junction block connectors?
Howdy!
I've finally got my GMC's electrical sorted out to the point that I am ready to start hooking stuff up. However, I want to route some new wires through the junction block instead of routing it through grommets in the firewall, and have found it nearly impossible to re-use those pins. Their tabs just snap off at the slightest bit of movement, even if you apply lots of heat. Does anyone know if anyone sells those pins aftermarket? I need like 15 of them, and the HELP! section dealies are 2 bucks a peice :eek1: Anyone have any suggestions? Or should I just do the ol' through the grommet type connections?
__________________
1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap) |
|
|
| Bookmarks |
|
|
Threaded Mode