steering arm removal - The 1947 - Present Chevrolet & GMC Truck Message Board Network

72-stomper · 06-13-2006, 11:51 PM

This shows the studs, cone washers, and locking nuts.

And here are the studs and cone washers part numbers. GM calls the cone washers "adapters".

Stud
3965137

Adapter (cone washer)
3965138

Each of these were about $3.50 a piece. So it cost me under $24 for the studs and washers per side. And GM does not sell the nuts (or at least my local dealer said they were not available). It is a 9/16-18 that's needed.

TriCounty Gear also sells the hardware separately. $20 for the 3 9/16-NF studs, 3 conical "washers" and the 3 9/16 aircraft "stover" nuts

06-13-2006, 11:51 PM	#16
72-stomper Registered User Join Date: Nov 2005 Location: wisconsin Posts: 142	Re: steering arm removal This shows the studs, cone washers, and locking nuts. And here are the studs and cone washers part numbers. GM calls the cone washers "adapters". Stud 3965137 Adapter (cone washer) 3965138 Each of these were about $3.50 a piece. So it cost me under $24 for the studs and washers per side. And GM does not sell the nuts (or at least my local dealer said they were not available). It is a 9/16-18 that's needed. TriCounty Gear also sells the hardware separately. $20 for the 3 9/16-NF studs, 3 conical "washers" and the 3 9/16 aircraft "stover" nuts



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.