|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-10-2006, 07:22 PM
|
#26 |
|
The LuvShack Garage
Join Date: Jan 2004
Location: Maple Grove, TN (West Side)
Posts: 30,468
|
Re: Surfer Rack Makeover Thread
Alloy used is 4026 for the short ones, & 6262 for the long ones due to a
minor screw up on my part drilling all the holes & the Dia. is .750 rnd sms, short rods are 41.75" long, long are 62.75" long, 1st holes are 6.25" if you measure forward from the rear ends, and then the holes are 50.5" center to center, the screws are metric 10 x 32 and 1.25" long, I used stainless allen head screws as pictured above instead of the traditional Phillips 
__________________
Owner/Op: "TN Classic Transport Carriers" The Toy: "Square Vette" 72 Hybrid Blazer Toy Barn: "LuvShack" 40 x 60 x 20 Shop Tow Piggy:"Maddy" 88 Silverado 3500 Hauler: "Feathers" 14 Aluma 8218T |
|
|
| Bookmarks |
|
|
Threaded Mode