Small block 350...will crank just fine, new starter/new battery and alternator. Doesn't seem to catch though...brand new fuel pump and carb...less than a week old. Pulled the line off of the carb to see if I have enough gas coming out of the pump and no clogs and we are good there. Just put a new coil/cap/rotor and plug wires on the HEI distributor 2 weeks ago. The inside of the distributor looked way way rusty...never seen one so bad. The motor will crank and crank, and just every once and awhile it will catch and I can get it to run alright when I hold open the throttle but once I let it go it slows down and dies really quick. Checked all my vacume lines, all are capped off or in good condition. Thinking the control module might be at fault because it just looked so bad in there...rusty and dirty wires leading to the cap etc. Oh yah checked the voltage running to the distributor and we are good there...new wires on it. Any suggestions? Thanks guys!!!
11-05-2002, 10:37 AM
Threaded Mode