C-Notch Woes

[fishmunger]

Ok So I'm through day 4 of doing my notches and havent even cut the frame yet! I spent the first two days busting off all the rusted carriage bolts to pull my bed floor, and the next two busting off all these gigantic rivets...ok

So I go to line up my notches (CPP btw) and I notice that on my driver side notch, in the back, the 2 holes that line up with the holes from the panhard mount (left after you bang out the rivets) are different than the picture in the FAQ section.

Lemme explain. The holes themselves line up correctly, but it appears my 64 has a different style panhard mounting point than the one in the FAQ section. So as far as I can see, I have to cut some out of my notch to clear the panhard mount and allow it to sit flush up against the frame. Not exactly "bolt-in."

My question is...anyone else run into this?

thanks,

Nate