dana 44 spicer hubs dials - The 1947 - Present Chevrolet & GMC Truck Message Board Network

mudmizer · 03-11-2007, 01:24 AM

Mine have been cleaned up and are working great. One of the plastic dials broke where the pin goe's through, one hole only, I drilled new holes clocked over about 6 degrees and it works just fine. Of course it dosen't have the little extra bit of plastic like the original hole area and the dial pointer is off just a tad, but hay it works for now. Metal would be great in the furure.

Special-K your right the machinest would need to take in accout the coating. A nice lathe and they could be fairly easy to make. Good idea.

03-11-2007, 01:24 AM	#26
mudmizer Registered User Join Date: Jan 2007 Location: Bellingham, washington Posts: 260	Re: dana 44 spicer hubs dials Mine have been cleaned up and are working great. One of the plastic dials broke where the pin goe's through, one hole only, I drilled new holes clocked over about 6 degrees and it works just fine. Of course it dosen't have the little extra bit of plastic like the original hole area and the dial pointer is off just a tad, but hay it works for now. Metal would be great in the furure. Special-K your right the machinest would need to take in accout the coating. A nice lathe and they could be fairly easy to make. Good idea. __________________ 68 4x4, 454, 4 speed, disk brakes both ends, Sold my 69 SS396 Elcamino when young & stupid



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.