Eaton Third swap parts list

[shelby987]

Well, I have had my eaton third with 4.10 gears and a locker sitting in my entrance way for probably about a year now....and a front axle with no driveshaft with the matching 4.10 gears sitting in my truck for about the same amount of time. It is time to install my eaton third, and I was hoping to get a parts list, as well as an install guide.

What is involved in pulling the existing third out of my truck?

What parts will need to be replaced (and what parts should be replaced as a good measure) Part numbers would be appreciated if possible, i know most of these parts will probably have to be ordered, and once I pull it all apart, I would rather not have to leave the truck high and dry (or wet as the case may be sitting outside).

Any instructions in the process would be appreciated.

I remember someone talking about putting the third in a bucket of diesel and spinning it to remove any loose dirt/sludge build up....anyone ever try that, how did it work?

Do you use special fluid for a locker, or just 80w gear oil?

Thanks!