1950 GMC Project... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

tylordurben · 05-10-2008, 03:29 PM

greg i am going to reuse the same wood bed floor, raising it 3"-4" from stock, it will sit on the top of the step notch (i made the top surface the same angle as the bed floor

) then ill make front, rear spacers and the center side rail chassis mount spacers. should work out nicely.

thanks kid, i got a lot of catching up to do to get where your at! even though we are not painting the truck there is a ton of work involved.

05-10-2008, 03:29 PM	#11
tylordurben Registered User Join Date: Apr 2008 Location: Miami, Fl Posts: 191	Re: 1950 GMC Project... greg i am going to reuse the same wood bed floor, raising it 3"-4" from stock, it will sit on the top of the step notch (i made the top surface the same angle as the bed floor ) then ill make front, rear spacers and the center side rail chassis mount spacers. should work out nicely. thanks kid, i got a lot of catching up to do to get where your at! even though we are not painting the truck there is a ton of work involved.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.