Wtt: Sbc Parts For Carb & Intake & Cntr Bolt Valve Covers

[soba_03]

OK folks I find myself in the middle of a project and in a quandry.
I'm building a 355 and have all the parts I need except Carb intake and valve covers.

Here is what I have up for trade
85 corvette block and heads, TPI Manifold If there is interest I'll provide casting numbers. The heads off this motor are 64CC if I remember correctly, I'm going to strip out the valves and springs.

The block is good it has 80,000 on it and with need cylinder bore checked, it didn't have any problems smoking or blow by. I will need boiled out been sitting a while, I know that thee crank is good (cast) and none of the bearings were bad on rods or mains. I'm also using the rods from this motor for my 355. The TPI Manifold is all there and I believe I even have the ECM and all the wireing.

Also I have 350 .030 over that has been dipped and checked it's a 2 bolt that is sitting in the shop. It's 88-95 block, I had it punched so it's never been run. Again it's just the block and main caps.


HERES WHAT I'M LOOKING TO GET:

I'm looking for 500 - 650 4 barrel and intake manifold for a small block.
I also need a set of center bolt valve covers for a small block.

THIS IS A SMOKING GOOD DEAL FOR SOMEONE...

I'M IN LOUISVILLE AREA IF THERE IS INTEREST I WILL SEND UP THE CASTING NUMBERS.

Just loking to trade some of the stuff I'm not going to use for stuff I'm in need of..

Thanks.....