The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > All 4x4 Tech & Off Roading > 4x4 Projects and Builds

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-12-2008, 09:16 PM   #11
Yukon Jack
Post Whore
 
Yukon Jack's Avatar
 
Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,686
Re: Project "Might as Well Make it Right While I'm at It!"

Not sure on the driveshaft - my present two piece driveshaft is new u-joints and carrier barrier as of about 1,000 miles at the most ago so I'd sure like to make it work. I'm sure I will have to shorten it a little - have to see how it works out.

I got the transfer case side mount brackets all drilled today and two spacers made. Also got the drop down bracket that my carrier bearing mounted to cut off. I'm ready to install the transfer case for the final time and then I can figure out the layout of the driveshafts. Good progress today.

I sure enjoy documeting my projects - I hope it can be helpful to someone else for sure.
__________________
1970 Blazer with a 400 sbc and 4" lift
1980 Pontiac Trans Am, 455 Oldsmobile
2012 Kawasaki Concours 14
Yukon Jack is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:08 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com