|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-04-2009, 06:41 PM
|
#1 |
|
Junior Member
Join Date: Dec 2006
Location: Newburgh, IN
Posts: 1,247
|
Welding update for ol Curt
I took some of your advice and clamped a copper piece behind the blow holes and welded them shut. Knowledge is KING!
 Also found out it is a good idea to wear some gloves when grinding as grinders bite if you are not careful!! I'm quite proud to see it go from a piece cut out that looked like this, to this... Not show quality work, but a start. But then of course there is the boo  boo |
|
|
| Bookmarks |
|
|
Threaded Mode