Not so budget 3-link build

[Twisted Minis]

Originally Posted by p8ntballer1911

Is a wishbone the same as a 4link, as in it need to be level at ride hight?

You would install it the same as a 4-link. Lower bars level or close to it at ride height, upper bar point down slightly towards the cab.

Originally Posted by abadsvt

Thanks for the insite! Wow 200psi and not even a little buldge! Thats great news. If you have any pics showing where you used the frame or cross braces as air tank I would love to see them. I am not going to do this for my current build but would like to keep that in mind for future builds. I am always doing my homework. Thanks again.

Josh

Here's some from when I was building it.

I capped the front of the rails where they transition into the stock frame.

Here you can see I cut two 1" holes on each side of the frame where another cross member will go.

Now the cross member in place, and the initial pressure test of 120 PSI. I let it sit for 3 days to see if it would leak down over time. It's all TIG welded, and I didn't find any leaks. Over 3 days it lost 2 PSI. I figure it was either in a fitting, the schraeder valve, the gauge, or a pinhole too small to detect. I later tested it to 200 PSI and let it sit for about 20 hours with no change in pressure.

Here's that cross member. I spaced the ports out so that the valves van be mounted to the frame.

And a last shot of it installed.