|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-28-2009, 10:04 AM
|
#1 |
|
Got big-block?
 
Join Date: Jul 2000
Location: Austin, Texas
Posts: 2,453
|
newby question about bolting on np205 and o-ring
Hi guys,
Finally putting the drivetrain into my '72 K25...468/4l80e/np205...I just have a question about sealing the transfer case to the transmission/t-case adapter. I've had the T400 adapter machined to fit in the rear of the 4L80e...I have the o-ring and gasket for the transmission side of the adapter...my question is, is there supposed to be an o-ring on the transfer case side of the adapter...I have the "figure 8" gasket...just need to know if I need an o-ring on this side as well, and if so, can you get them at NAPA, A-zone, etc.? Thanks, Casey
__________________
'68 CST SWB factory 396/T400 buddy buckets, a/c, ps, pb '72 Corvette convertible 454/4spd/ac, ps, pb '73 GMC Sierra Grande short wide 454/T400 ps, pb, ac '77 K5 Blazer black on red, 350/T350/NP205 ps, pb, ac all original '78 GMC Sierra Classic short wide 454/T400 ps, pb, ac '72 GMC Sprint SP454. 1 of 38 built. '73 GMC Sprint SP454. 1 of 71 built. '75 GMC Sprint SP454. 1 of 25 built. SOLD! '72 GMC K25 4x4 468/4L80e/NP205 build thread http://67-72chevytrucks.com/vboard/s...23#post4324423 SOLD!'55 Chevy gasser 496/4spd build thread http://67-72chevytrucks.com/vboard/s...96#post4324396 |
|
|
| Bookmarks |
|
|
Threaded Mode