|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-24-2009, 04:15 PM
|
#1 |
|
Senior Member
 
Join Date: Dec 2006
Location: Studio City, Calif.
Posts: 2,886
|
Two-piece drive shaft phasing
I must have been asleep during this lesson.
I have a two-piece DS that vibrates and seems to go through middle u-joints too quickly. Does anyone have a diagramn or description of how it is supposed to be phased? There is no special "alignment spline" like the haynes manual describes. Thanks! WLH
__________________
'69 GMC C2500 Custom Camper, 8 1/2' bed, New GM 350, NP 435 Close Ratio 4spd. Trans., 3.73 Dana-60 open.Camper and Trailer wiring, PS, PB, AC, tach , three gas tanks, stereo speakers, 2nd owner, Work-Truck supreme. |
|
|
| Bookmarks |
|
|
Threaded Mode