Started making my wishbone - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Tri5Nerd · 05-08-2009, 01:02 AM

Tell me what you think of the construction.
Tubing is 1.25" OD, .25" wall DOM.
Angle is 47* at the front and 19" to the 50* bends.

I need to cut about 3" off the part that will sit on the axle.
Did this is welding class tonight using the tube notcher and bender and TIG.
Third time using the TIG, been doing more Gas and stick, stick is hard to do overhead.

I'll make some gussets and brackets to go on the axle next week.
What size bushings should I get for this setup?

Tri5

05-08-2009, 01:02 AM	#1
Tri5Nerd Tripple Five Fanatic Join Date: Sep 2006 Location: USA Posts: 658	Started making my wishbone Tell me what you think of the construction. Tubing is 1.25" OD, .25" wall DOM. Angle is 47* at the front and 19" to the 50* bends. I need to cut about 3" off the part that will sit on the axle. Did this is welding class tonight using the tube notcher and bender and TIG. Third time using the TIG, been doing more Gas and stick, stick is hard to do overhead. I'll make some gussets and brackets to go on the axle next week. What size bushings should I get for this setup? Tri5 Attached Images Last edited by Tri5Nerd; 05-08-2009 at 01:07 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.