|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
02-13-2010, 05:01 PM
|
#1 |
|
Eat My Rust
Join Date: Jan 2007
Location: Cypress, Texas
Posts: 3,362
|
Pan Hard bar problem after axle swap
The large stud that comes off the axle housing on the new GM 12bolt is shorter than the one from the Dana 60 that just came off. The bar is lined up too far towards the rear of the truck to bolt up to the GM 12 bolt. What gives? Is there a different legth stud that can be found? Can't swap the studs between the axles, since the Dana's is thicker...
Last edited by texanidiot25; 02-13-2010 at 08:30 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode