|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-21-2010, 08:18 PM
|
#1 |
|
Registered User
 
Join Date: Feb 2000
Location: Maquoketa, Ia/ Orr, Mn
Posts: 3,095
|
driveshaft mesurement needed
I'm in the process of swapping out my 203 transfer case for a 205 and I need to know how long the rear driveshaft needs to be because I might need to have one made. I don't have the 203 out of the truck yet so I can't get a good measurement. My truck specs;
3/4ton 350, SM465/205, 14 bolt ff rear axle and 6 inches of lift. I know a stock driveshaft from a stock K-20 truck with the 465/205 and 14bolt rear will work but they're getting hard to find, almost impossible. I need the measurement from the flat edge (where the u-joint u-bolts go through) of the transfercase yoke to the flat edge of the pinion yoke at ride height. This diagram explains it better than I can. http://www.driveshaftspecialist.com/...kes%202009.JPG Anyone reccommend a driveshaft builder?
__________________
'51 South Bend Model "9A" '56 Chevy 3600 NAPCO '74 Chevy Cheyenne Super K20-restored on 37's '72 GMC Sierra Custom K2500- in progress '08 GMC Envoy Denali '12 GMC Sierra 2500HD Denali '17 GMC Yukon XL VCCA member #58596 http://www.nohrco.com Last edited by MJN; 03-21-2010 at 08:27 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode