Bench seat swap info needed... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

nxtruck · 04-06-2010, 11:57 PM

Guys, I posted this in the 60'-66' section, but thought I'd post a thread in here, too.
I'm planning on swapping my race buckets for a bench seat, but here's the catch: I can't fit a seat any wider than 55" in my truck, because of the rollcage. Does anyone have any info on what applications would use a bench seat approx. this wide? Has anyone swapped seats out of another vehicle and have the dimensions on the seat? I tried contacting the local salvage yards and asking a few questions, but they were both of limited help.
So, if anyone has any suggestions or info, I'd really appreciate it!!
Thanks in advance!!

04-06-2010, 11:57 PM	#1
nxtruck Registered User Join Date: Jun 2006 Location: Jackson, Mo. Posts: 607	Bench seat swap info needed... Guys, I posted this in the 60'-66' section, but thought I'd post a thread in here, too. I'm planning on swapping my race buckets for a bench seat, but here's the catch: I can't fit a seat any wider than 55" in my truck, because of the rollcage. Does anyone have any info on what applications would use a bench seat approx. this wide? Has anyone swapped seats out of another vehicle and have the dimensions on the seat? I tried contacting the local salvage yards and asking a few questions, but they were both of limited help. So, if anyone has any suggestions or info, I'd really appreciate it!! Thanks in advance!! __________________ Chris 1966 Chevy C10 LWB, 434 sbc, TH350, 12-bolt, factory suspension, pump gas 7.02 @ 95.8, 1.45 60' 1965 Chevy C10 LWB, 355 sbc, TH350, daily driver



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.