Removing ECM (I hate wires) - The 1947 - Present Chevrolet & GMC Truck Message Board Network

bikes&bowties · 05-31-2010, 01:04 PM

This would be on a 84 k10. I swapped in a crate 350 and an sm465. I have got rid of most of the transmission hookups that went to the 700r4. What would be the down falls of putting in a non-computer controlled distributor and carb. I have the distributor and carb to use so thats not a problem... I havent looked at the wiring diagram to much but I was hoping it would be simple enough to pull it all out and if needed by pass any hot wires needed for running other things.. Thanks in advance for any help.

05-31-2010, 01:04 PM	#1
bikes&bowties Registered User Join Date: May 2009 Location: Washington Posts: 663	Removing ECM (I hate wires) This would be on a 84 k10. I swapped in a crate 350 and an sm465. I have got rid of most of the transmission hookups that went to the 700r4. What would be the down falls of putting in a non-computer controlled distributor and carb. I have the distributor and carb to use so thats not a problem... I havent looked at the wiring diagram to much but I was hoping it would be simple enough to pull it all out and if needed by pass any hot wires needed for running other things.. Thanks in advance for any help.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.