|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-12-2003, 11:23 AM
|
#1 |
|
Almost Satisfied
 
Join Date: Mar 2002
Location: Springfield, MO
Posts: 2,932
|
Can a bed side be straightened?
I have two left side stepside bed sides (say that three times fast) anyway, if you look at them they have a concave curve to each of them. I can push the bed side back in with my knee, but it pops right back to the "bent" position.
Is there anyway to shrink the bedside metal to make it flat again? Otherwise, both of these sides are very usable so I hate to chuck out $400 for a new one.
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far." |
|
|
| Bookmarks |
|
|
Threaded Mode