Pic request: Rack and Pinion Notch for Dropmember

[PBFAB.COM]

Originally Posted by biohazardbill

I am laying this out and the instructions I have there is an oblong hole that remains after installation in the pic. The pic I believe is from a newer frame. On my frame an oblong hole is at the 2.5 inch down mark and will be completely removed if what I did was correct. So before i cut this out does anyone have some good pics I could use as a reference?

I appreciate it.

The oblong hole you are referring to does change location bewteen the different chassis years. Go off the measurements here and you will be good to go: http://www.porterbuiltfabrication.co...n-Instructions