|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-23-2011, 07:54 PM
|
#1 |
|
Blackdawg
Join Date: Aug 2010
Location: North Delta ,British Columbia
Posts: 213
|
fitting edelbrock intake manifold
In the process of doing my build i put a edelbrock performer intake on my 350.For the intake gaskets i replaced them with edelbrock.the front and rear seal are from my gasket kit.I haven"t bolted the intake down yet but does seem to be a bit of a gap where it meets the front seal.i would assume the same for the back.any ideas on the one.i saw a thread where someone said not to use the front and rear seal.
|
|
|
| Bookmarks |
|
|
Threaded Mode