|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-20-2011, 07:33 PM
|
#1 |
|
Registered User
 
Join Date: Feb 2008
Location: Omaha, NE 68144
Posts: 333
|
Lifting points to remove motor/trans
I'm getting ready to pull my 292/sm465 & can't figure out where to hook the lift chains as there's no lifting loops/straps on the motor. Should I remove the intake/exhaust manifolds & use some of those bolt holes?
Also, my truck is all stock & the trans xmember is still riveted in the frame. Can the motor & trans be pulled together without removing the xmember first? I have removed the core support, grill & bumper to minimize lifting angles. Any suggestions would be greatly appreciated.
__________________
Bryan '52 Bel Air 2dr HT - in pieces '68 C10 - 6cyl/4spd REMOVED, LT1/T56 to be installed “Any society that would give up a little liberty to gain a little security will deserve neither and lose both.” - Benjamin Franklin "And those who know what's best for us, Must rise and save us from ourselves" - RUSH lyric (mockery) |
|
|
| Bookmarks |
|
|
Threaded Mode