Introduction and Question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

beaterC10 · 07-31-2003, 01:36 PM

I'm new to the board, joined last week. Thought I should introduce myself. My name is Dave Reasoner. I have a 84 short stepside beater that gets my attention when I have spare time. You guys with kids probably understand 3 kids and a wife take a lot of my time.

My question concerns the New Process 833 4 speed O/D manual trans. apparently used in the 80's by GM and Chrysler. Is it a good enough trans to warrant swapping one into an auto equipped truck?

I have one from a GM truck and most of the parts required to swap over to a clutch. I was wondering if the manual trans 1/2 ton 2wd used the small or large hump cabs from the factory.

I would appreciate any insight you guys may have. Thanks

Dave

07-31-2003, 01:36 PM	#1
beaterC10 Senior Member Join Date: Jul 2003 Location: Indianapolis, IN Posts: 1,277	Introduction and Question I'm new to the board, joined last week. Thought I should introduce myself. My name is Dave Reasoner. I have a 84 short stepside beater that gets my attention when I have spare time. You guys with kids probably understand 3 kids and a wife take a lot of my time. My question concerns the New Process 833 4 speed O/D manual trans. apparently used in the 80's by GM and Chrysler. Is it a good enough trans to warrant swapping one into an auto equipped truck? I have one from a GM truck and most of the parts required to swap over to a clutch. I was wondering if the manual trans 1/2 ton 2wd used the small or large hump cabs from the factory. I would appreciate any insight you guys may have. Thanks Dave



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.