Cleaning a bare frame - Suggestions? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

JesseSimon · 08-30-2011, 09:27 PM

Hey guys, getting ready to start what will basically be a ground up build. Have a '66 LWB that I am swapping over to a '65 Short Stepside frame and bed. Just picked up the 65 stepper and it is COMPLETELY disassembled. So I have a bare frame. just rails and cross members. I want to clean it all up and put a good coat of paint on it before I start building on it. This is a budget build, anyone have an alternative cleaning method to sandblasting that they can suggest or should I bite the bullet and blast it?

08-30-2011, 09:27 PM	#1
JesseSimon Asks alot of questions Join Date: Feb 2009 Location: Rogers, Arkansas Posts: 231	Cleaning a bare frame - Suggestions? Hey guys, getting ready to start what will basically be a ground up build. Have a '66 LWB that I am swapping over to a '65 Short Stepside frame and bed. Just picked up the 65 stepper and it is COMPLETELY disassembled. So I have a bare frame. just rails and cross members. I want to clean it all up and put a good coat of paint on it before I start building on it. This is a budget build, anyone have an alternative cleaning method to sandblasting that they can suggest or should I bite the bullet and blast it? __________________ MY STABLE: '66 C10 LWB turning it into a shortbed stepside '77 LWB (my daily driver).....oh its a FORD ahhhhh! '07 MAZDA 3 (the wife's ride)



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.