|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-08-2011, 03:53 PM
|
#1 |
|
Registered User
Join Date: Jan 2008
Location: HOUSTON TX
Posts: 1,161
|
Tube bender is finally done
Got some plans off the Internet and built this thing about a year ago. Finally got the dies in for it and is sure does a fine job. This is 1.5" x .095 wall tube that even has a seam in it. I know, I know, I will use D.O.M when i figure out how to use it. This tube was only 17.00 for a 20' joint. It sure is nice having good tools that you build yourself.
|
|
|
| Bookmarks |
|
|
Threaded Mode