Reassembling the upper and lower a-arms.

[no moa]

Now i have been into cars my whole life, but never have i done a truck front end. So i'm not sure where to start, these are just set on there, i have all the shims, also i have a 69 manual, and my truck is a 72. I'm guessing they are the same other than the discs?

Here is where i'm at, and what i'm using. Am i to assume just torque the threaded ends to 160 FT LBS. It says to center the bushings in the arms, but i see know way to center it, as i can thread them completely in both sides.

Maybe i'm missing something, (wrong manual?) but they are the same as the ones i removed, and those were all loose, so i couldn't get a meausurement.

Thank for any help.