72 K5 Blazer engine/trans swap 5.3/4L60

[mcbassin]

Originally Posted by Gunny Davis

I am going to have to fab up the motor mounts so I need some help with the position of the motor in the frame.
How do I find the proper height and angle for the engine before I fab motor mounts?

Motor mounts have been much more difficult then I anticipated. I read all the "easy adapter plate" advise on here only to find that my 4WD crossmember will not fit the 5.3. So stock mounts are out of the question. I have decided to go with some like the pic just need to find some 5inch c-channel for the box.
http://67-72chevytrucks.com/vboard/a...1&d=1318632365

Gunny,
Where did you find the attached picture? Did you end up making this style mounts? If yes, Did you happen to make a sketch or drawing of what you made with dimensions? thanks