CPP Motor Mounts and Tranny support question

[mlevario99]

I just install my 5.3 engine into my 68 suburban, but I notice that on the passenger side the oil pan is rubbing just a bit into the cross member, I install the CPP engine mounts in the front most holes, is that where is supposed to go, or do I need to installed them in the back holes. If I installed them inthe back holes, do I need to drill a hole for the bolt that goes into the cross member. As it is right now, with the motor mounts in the front the tranny support from CPP does not line up with the holes from the chassis.

I am attaching 2 pictures