406 SBC, intake and carb FS

[Destructo]

I have a 406 4 bolt main block that has been bored .030" over, hot tanked and painted, its ready to go together, also have the crank which needs to be ground because of rust that formed on it while the PO had it, rough looking heads but was told they should not be cracked, also the original pistons and rods. Rods look like they can be cleaned up and used again with some minor work. They are complete with valves 1.94 and 1.5 with 76cc chamber. The block is a '72 year. I'm asking $500 for the whole lot, also have the pushrods, a couple rusty chrome pulleys and a chrome timing cover.

Also have an edelbrock Torker 2 manifold, asking 50 for it. It came off a perfect running 350 that had less than 20k miles on a rebuild and was pulled because my friend needed something emissions legal.

Edelbrock 1406 carb that was working perfect when I took it off my truck and put a Holley 1460 on I had bought. I couldn't tell that there was anything wrong with it. I'm asking 75 for it.

Any of these prices are negotiable and I don't want to ship the engine, I will ship the carb and intake though.

I'm located in Lewisville NC 27012 email me at chad@martiansales.com or send me PM or just reply to this thread. I can get you pictures of any of the stuff if you want, just let me know. I will post them here or email them to you.

One last thing, if anybody is interested in a set of 10 bolt front and rear axles with 2.73 gears and a locking rear I will be swapping them out from under my truck soon.