|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-27-2012, 04:53 PM
|
#1 |
|
Registered User
Join Date: Mar 2011
Location: Tacoma
Posts: 134
|
Need help with a clearance issue
I just installed 3" DJM lowering springs, CPP Modular 2.5" drop spindles and cross drilled rotors. The problem I'm having is when I set it down the ends of the lower control arms hit the back side of the rotors. Has anyone else had this problem and if so how did you resolve it? I am considering cutting about an 1/8" off the ends of the lower arms or removing some of the alignment shims from the top arms.
   Posted via Mobile Device
__________________
If you are on Facebook check out our group. northwestc10s@groups.facebook.com Chris Fowler Last edited by BlueEK9; 05-27-2012 at 05:02 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode