|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-04-2012, 02:26 AM
|
#1 |
|
Registered User
Join Date: Jun 2009
Location: Corona, ca
Posts: 406
|
Pinion/tailshaft questions
At the point where I need to set the ride height before I mount the cab and was wondering.
On the 4l60e where do I measure the angle? Also on the rear do I measure on the drive shaft or at the point on the rear? Also, is that yolk out too far in the trans? it is about 4" long and about 2 of it is out. 4L60e tailshaft  Rear 
|
|
|
| Bookmarks |
|
|
Threaded Mode