|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-01-2012, 11:43 AM
|
#1 |
|
Registered User
Join Date: Mar 2012
Location: Lincoln, IL
Posts: 880
|
Retro-fitting roller lifters in 2 piece rear main seal blocks...
OK. so i have my 400 cubic inch small block lying around in pieces. the thing was pressure checked, looked at and everything. havent had it machined yet, filled the block half way on one side gonna fill the other side here soon
 . Lost one main cap and it wasnt pretty  i about went off the hinges. Then i purchased new splayed mains tapped and drilled myself and arp studs. thank god i still have original rear main and front cap.. But now there is plenty of time and hope to make this engine great for my truck  . i have done some reading, reading, looking at shiny stuff while doing so.. researching sbc to the fullest. so i cam acoss this and it seems fate would have it i can afford a roller set up like thishttp://www.nastyz28.com/forum/showth...190146&page=14Tell me what you think
__________________
Her name is Quicksilver 1978 Chevrolet silverado, shortbox stepside currently being swapped IN is a LM7 5300 vortec, 4l80E, factory 4.11s, slammed, a dream ride and coined QUICKSILVER gotta pay $$ if you wanna play 
|
|
|
| Bookmarks |
|
|
Threaded Mode